INSTALLATION
- Copy the OS2WWWxx.ZIP file into a directory named "\PowerWeb" and
change your current directory to "\PowerWeb".
- Unzip using either pkunzip or unzip as follows:
unzip -x os2www.zip
pkunzip -d os2www.zip
Note: It is important to use the command line switches shown above to
create the sub-directories below "\PowerWeb".
- Running install, according to your IP ADDRESS:
- If you are using a dynamic IP address, (in other words you do not
have a permanent Internet connection) then ensure that your
HOSTS file in your \mptn\etc or \tcpip\etc directory contains the
following line:
127.0.0.1 localhost
and then run
INSTALL -local
and follow its instructions carefully, and fill in all forms completely.
- If you are using a permanent IP address, then run
INSTALL
and follow its instructions carefully, and fill in all forms completely.
-
The INSTALL program will tell you which URL page to load into your browser
to continue the installation. You cannot continue without having
run INSTALL first.
- Do not delete the OS2WWWxx.ZIP file after a successful installation,
it has been moved to a system directory, in case you need to re-install.
IN CASE OF PROBLEMS
Read these notes on correctly
setting up TCP/IP under OS/2
for PowerWeb.
README
Point your browser here to read the Readme.Txt file,
which contains additional information on how to setup PowerWeb Server++.
Copyright © CompuSource
All rights reserved.
source@iaccess.za